VDO SENSORS - FOR ENGINE MANAGEMENT V3.0 Manuel d'utilisateur télécharger pdf (Page 17)

PAGE

www.motec.com

RETAIL

JANUARY 2012

ECU Accessories

Part No. Price

Ignition Expander 14001 268.00

AS Connector Ignition Expander (needs connector 68087) 14006 373.00

Traction Control Multiplexer 14002 268.00

AS Connector TC Multiplexer (needs connector 68087) 14005 373.00

Pierburg Boost Control Valve (includes connector) 58004 121.00

M4/M48 SUU Software Update Unit

63008 107.00

3 Port Boost Control Valve 58020 94.00

ECU Accessories include a mating connector unless otherwise stated

ECU Accessory Connectors

22 Pin Autosport IEX/TCMux Connector (AS612-35SN) 68087 65.00

DBW-4 Drive By Wire Module

Part No. Price

The DBW-4 works with M400/M600/M800/M880 ECUs running firmware V3.30T and later, and

provides 4 PID Controllers for drive by wire control, or generic PID control for servo motors. The

use of a DBW-4 does not require a DBW upgrade in your ECU. Mating connector not included

MoTeC DBW-4 14011 815.00

66 Pin Autosport DBW-4 Connector (AS618-35SN) 68089 101.00

Knock Monitoring and Control

Part No. Price

OKM Onboard Knock Module (for M800 P&P ECUs) 53115 556.00

Mitsubishi EVO X OKM Onboard Knock Module 53121 556.00

SKM Standalone Knock Module 53116 796.00

Knock Sensor Loom (for use with SKM) 61114 252.00

Knock Modules work with vehicle knock sensors to provide individual cylinder closed loop knock

control, allowing tuners to safely optimise high performance ignition maps. There is a standalone

module and a version specifically designed to mount onto an M800 Plug-In ECU. A competent

tuner needs to carry out a frequency analysis to determine the target frequency and knock module

settings. This is highly specialised work.

MoTeC Knock Modules will only be available through authorised dealers that have under-

taken specific training

DHB Dual Half Bridge

Part No. Price

DHB Dual Half Bridge (needs connectors 68050, 79121, and

79125 — see page 24)

41213 295.00

The DHB is a high current amplifier which allows low current auxiliary outputs to drive high current

loads such as motors. It contains two high current half bridge outputs, and connects to any auxil-

iary output of a MoTeC ECU or Dash Logger, which performs the control function, such as PWM

speed control, direction control or servo control. Mating connectors not included

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

VDO SENSORS - FOR ENGINE MANAGEMENT V3.0 Manuel d'utilisateur Page 17

Commentaires sur ces manuels